Your Cart is Empty
CG20PB2
$29.00
Use a drill tube within ±0.02 inch (±0.508 mm) of the measured cable diameter. Choose the closest available size within this range. If none of the supplied 6, 8, 10 or 12 mm tubes qualifies, use a matching-size tube. Keep at least 0.125 inch (3.175 mm) of rubber between holes and at the outside edge.
The Seaview Retrofit Cable Seal is the only guaranteed and proven watertight installation for your currently installed cables! In a new category of its own, the Retrofit Cable Seal provides a watertight installation for your currently installed cables. No need to re-run your cables, simply install with your cable in place! The Seaview Retrofit Cable Seals provide a waterproof pass-through for antenna, transducer, lights, power and other cables without removal of the factory installed cable connector.
These Cable Seals will work with more than one cable as long as each cable has its own hole and there is at least .125" of rubber around each hole.
| Seaview Part Number | Dimensions |
| CG20PG2 / CG20PB2 (small round) | Download |
| CG30PG2 / CG30PB2 (large round) | Download |
Download the installation instructions in the chart below.
| Seaview Part Number | Installation Instructions |
| All Retrofit Cable Seals | Download |
Marine - Radars, satellite domes, cameras, lights and more!
Automotive - Seal the cables from your exterior lights going into your vehicle. Satellite domes for RV's.
Home - Easy installation to clean up current cables entering the house. Paintable shell to match the color of your house. Small in diameter and profile to fit in most applications. Extremely durable in all weather conditions.
Install with cable in place! No need to remove cable connectors or cable at all. Features captive nuts. All hardware provided for easy installation.
IPX6 and IPX7 waterproof rating. Uses a tapered watertight rubber seal and base gasket.
