APEX mounting solutions for RVs and vehicles

Need help choosing the right fit?Use Cable Seal Selector Guide

Find your cable seal

Measure every cable jacket and the widest part of every connector. Then choose vertical or horizontal entry, the number of cables, whether an installed cable needs a split retrofit housing, and the required material and finish.

How to choose a waterproof cable seal

Measure every cable jacket and the widest part of every connector. Then choose vertical or horizontal entry, the number of cables, whether an installed cable needs a split retrofit housing, and the required material and finish.

What drill-tube size should I use?

Choose the closest drill-tube diameter within ±0.02 in (±0.508 mm) of your measured cable diameter. A tube may be smaller or larger by no more than this amount. If none of the supplied 6, 8, 10 or 12 mm tubes qualifies, use a matching-size tube. The hole layout still needs at least 1/8 in of rubber at the edge and between holes.

Can one cable seal hold multiple cables?

Each cable needs a separate hole with at least 1/8 in (3.175 mm) of rubber between holes and at the outer edge. Round vertical seals can nest holes; horizontal seals keep them in a row. The selector checks hole layouts and suggests drill-tube sizes. CGM90 uses its factory-marked drill centers.

What cable and connector sizes fit CGM17?

This guide uses a maximum cable diameter of 12.7 mm (0.50 in) and a maximum connector diameter of 17 mm (0.67 in) for CGM17. Check the connector shape, installation drawing and actual cable route before drilling.

When do I need a retrofit cable seal?

A split retrofit housing assembles around a cable that is already installed and cannot be re-run. Check the existing surface hole, coverage and screw locations. Standard vertical and horizontal cable seals have different installation requirements.

How should I use the hole layout drawing?

The top-down planning view shows each entered cable diameter, minimum edge rubber, suggested drill tubes and razor-cut lines from hole edges to the rubber edge. Enlarge or download the drawing, then verify it against the actual rubber plug and installation instructions. It is not a drilling template.

Browse cable seal products and installation information

Cable seals · Instrument and display pods · Installation instructions · Find a Seaview dealer